Comments 5 Galil_RobinR on 08/05/2014 - 10:06 ehodzic@eclips… on 11/27/2014 - 08:08 Just looking at the code. I think that for the #ZON subroutine right after WT100 it should be SB3. We should set the output bit if motor is enabled. Same for the #ZOFF the SB3 should be replaced with CB3. Can somebody comment / help please Kenatic on 08/05/2014 - 18:44 Kenatic on 08/05/2014 - 18:44 Galil_RobinR on 08/06/2014 - 10:25 Log in or register to post comments
ehodzic@eclips… on 11/27/2014 - 08:08 Just looking at the code. I think that for the #ZON subroutine right after WT100 it should be SB3. We should set the output bit if motor is enabled. Same for the #ZOFF the SB3 should be replaced with CB3. Can somebody comment / help please
Galil_RobinR on 08/05/2014 - 10:06
ehodzic@eclips… on 11/27/2014 - 08:08
Just looking at the code. I think that for the #ZON subroutine right after WT100 it should be SB3.
We should set the output bit if motor is enabled.
Same for the #ZOFF the SB3 should be replaced with CB3.
Can somebody comment / help please
Kenatic on 08/05/2014 - 18:44
Kenatic on 08/05/2014 - 18:44
Galil_RobinR on 08/06/2014 - 10:25