Dear Sir
We have a DMC2143 Motion Controller & Latest RIO DMC31011 Single Axis Controller.
We want to connect this on Ethernet modbus. we are using TH command & IHC = 192.0.168.3 but DMC31011 controller will not response.
Could you please advice what to do.
Regards
Sameer
Galil_DJR on 10/04/2013 - 08:39
Hello,
Please note that the DMC31011 has a different communications feature set than the RIO products.
Please ensure you have the newest DMC-31010 firmware. Modbus support for array access was added at 1.2a, circa July.
http://www.galilmc.com/support/downloads/firmware_rev/firm30000.html#12a
If you do have up-to-date firmware, the next step would be to check TC1. Do you get an error after the IH command?